Sealing Your Garage Door to Make It Weathertight (2025)

Home Improvement

Interior Remodel

Garage

Keep out the Weather With New Garage Door Seals

• 01 of 05

  Garage Door Bottom Seal

  

  The garage door bottom seal (or door sweep) is along strip ofrubber or vinyl that attaches to the bottom edge of the garage door. The flexible material compresses when the door closes, sealing the gap along the floor to keep out water, dirt, cold breezes, and critters. You'll know it's time to replace the bottom seal when you can see daylight below the bottom of the door when it is closed. You might also feel a draft or see water if the outside of the door gets wet.

  Wood garage doors typically use a simple strip-style seal with angled edges that seal against the front of the door and the floor. These typically are installed with galvanized or aluminum roofing nails.

  Metal garage doors typically havean aluminum channel on the bottom of the door that holds a U-shaped rubber gasket, sometimes called a T-style or astragal seal.The gasket simply slides into two small tracks on the channel for installation. You can also install a metal gasket channel onto a wood garage door so you can use this type of gasket.

  In addition to their easy installation, the best thing about U-shaped gaskets is that they come in different sizes to seal gaps of various heights. This can be an easy solution for large gaps created by sunken or cracked garage floors.

• 02 of 05

  Garage Door Threshold Seal

  

  A threshold seal serves a similar function to the bottom seal on a garage door, butit is attached to the garage floor rather than the door. Thresholds can be used alone or in conjunction with a door seal. Thresholds often are used to keep out surface water when a driveway slopes down toward a garage. They can also help fill a large gap below a door.

  A good-quality vinyl threshold seal can be more durable than a door seal. It is installed with an adhesive that is usually included with the threshold.

  Keep in mind that thresholds block watergoing out of a garage, just as they keep it from flowing in. This can be inconvenient if you like to hose out your garage. A threshold also makes it difficult to sweep dirt and debris out of the garage.

• 03 of 05

  Garage Door Stop Weatherstripping

  

  Wind and rain can also get into the garage around the sides and top of the garagedoor. To prevent this, garage doors usually have rubber or vinyl weatherstripping installed onto the wood door stop molding that is attached to the door jamb and nearly touches the front face of the door.

  Install new weatherstripping onto your door stops if your garage door doesn't have it or if it has old, worn stripping that nolonger seals against the door. New weatherstripping comes in rolls, and you can easily cut it to length with a utility knife. It installs with galvanized nails or screws. The door-side flange of the weatherstripping should press against the door to create a good seal.

• 04 of 05

  Vinyl Door Stop With Integrated Weatherstrip

  

  Door stop molding with weatherstripping is a great option for doors that have old, rotted, or damage door stops that need replacing. This specialty stop molding typically is made of vinyl and has a wood-look molding strip and a flexible weather-seal flange all in one piece. It cuts easily with a saw and installs with galvanized or stainless steel siding nails.

  To install the door stop, position each piece parallel to the door face, and push the molding toward the door so the weatherstrip flange is slightly compressed against the door, and then fasten the molding to the door jamb with nails. Typically, it's best to install the top molding first and then overlap the ends of the top molding with the side stops.

  Continue to 5 of 5 below

• 05 of 05

  Garage Door Panel Weatherstripping

  

  V-shaped garage door panel weatherstripping is designed to seal the gaps between individual door panels. This can be particularly helpful on older wood doors with panels that have flat edges. (Newer metal and fiberglass doors usually have interlocking edges to prevent air intrusion.)

  Door panel weatherstripping is sold in rolls and is self-adhesive. You simply stick it to the top or bottom edge of each panel. When the door is closed, the panels compress the weatherstripping to create an effective seal, much like weatherstripping on standard house entry doors.